I love being able to make cute 3D items. Here is the Beary Cute bear in an ornament. I used the mirror-image technique because you can see the bear on both sides. Click here to see the Beary Cute Ornament Supplies.
I stamped the bear and tree on both side of the Basic White cardstock using the Stamparatus and Silicone Craft Sheet. I stamp the scarf like normal on the front of the bear, cleaned and dried the stamp good, covered the scarf ends with tape, inked up the stamp again, removed the tape and stamped just the neck part on the back of the bear. I punched out the bear and cut the tree out with Paper Snips. I used a scrap of cardstock to attach the bear and tree to the lid of the onament. I then fluffed a cotton ball and attached it on the lid with a little hot glue to cover the scrap of cardstock base and give it a snowy effect.
Back of OrnamentI used the sitting bear in this ornament. I repeated the same steps except cut out the bear and tree.
Beary Cute Ornament Alternate 1
Beary Cute Bundle itm #162023
Click to see Resources
